Turn the power on while pressing the OMR sensor. This information is released as of December Is the power of the scanner turned on before turning on the power of PC? With Windows, it is reported that all FJ scanners have a problem when operating. Fujitsu fi Series Image Scanner Product.
|Date Added:||11 May 2016|
|File Size:||46.67 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Use the following procedure to make the scanner select one of the four product IDs: Changing product identification 4. Turn the power on while pressing the OMR sensor.
We have no plan to support this problem, please use another board. Probable trouble at scanner connection.
Software Downloads: M3096GX / M3093DG / M3093GX / M3092DC / M3091DC
Please check the followings. Fujitsu fi Series Image Scanner Product.
Please check the following items first. If the lamps are not turned on or off as shown in Table 1, repeat this step.
Is the option board of the scanner installed correctly? With Windows, it is reported that all FJ scanners have a problem when operating. Is your diver of SCSI board installed correctly? Is the power of the scanner turned on before turning on the power of PC? Open the ADF cover all the way. Is the scanner supported by the driver connected? After confirming the lamps in step 2press the B5-size sensor again.
Some causes are probable regarding this error message. The transition status is recognized by the LEDs. However, the effective speed of this interface is 1MBPS. This information is released as of December There is not any problem with WindowsNT 4. The file fujitau not been installed or have deleted.
Sensor location MGX Figure 2.
Fujitsu fi Series Image Scanner Product
When using MD under Windowsa problem is reported that the endorser imprinter can not print correctly. We are confirming a detailed cause. Is the power cable of the scanner connected correctly and the scanner power turned on? Is the scanner in the state of “Ready to operate”? DILL using 16 bit version are not found.
When the scanner enters ID change mode, the lamps are turned on or off as zcanner in Table 1 for the product ID change mode. Is the terminator set properly?
When you stop pressing the OMR sensor, the lamps are turned on or off as shown in Table 1 according to the current ID. Contacts Related links Sitemap. The most popular USB interface is called Version1.
This message appears when the driver can not receive answers from the scanner. Is the power of the scanner turned on? Are the terminators of all devices set correctly? Does your driver support your operating system?